Horizontal Vinyl Blinds - 2" Vinylux Blinds

Spacers

Spacer blocks project the blind or shade 3/8” from the mounting surface .Use spacer blocks to obtain clearance when obstructions such as window cranks, door handles or trim, obstruct the movement of the blind or shade.

Available at No Extra Charge

Hold Downs

Hold down brackets are made of a metal which fit into holes in the end cap of the bottom rail. Hold downs are generally used to secure the bottom of the blinds to prevent swaying.

Available at No Extra Charge

Standard 2 slat matching valance

Available at No Extra Charge

Lift Cord and Tilt Cord

The lift cord is used to raise and lower a blind or shade. This allows the blind or shades to be stopped at any time to the desired position.

Tilt cord is used to open and close the slats. Operation of a tilt cord is very easy and much easier than a wand to rotate the slats. It always recommended to select a tilt cord for wood or faux wood blinds. Controls vary by each product or size restrictions.

Available at No Extra Charge

Wand Tilt

Wand Tilt is a pvc rod used to rotate the slats to the desired postion.. Controls vary by each product or size restrictions.

Available at No Extra Charge

Cord Cleats

Cord cleats are used for blinds or shades. This feature will allow the cord to be wrapped around a clear plastic clip. It is very simple to install the clips to your wall, only one screw is needed and that is provided for you. This will help prevent cords from dangling and giving the area a cleaner look. These are free of charge. When placing your order you will have to request cord cleats.

Available at No Extra Charge

2-on-1 or 3-on-1 Headrail

2 or 3 on 1 headrail feature is used for larger windows that would be more difficult to raise or lower or blinds that are not within the size requirements. All the blinds will share a common valance ( 1 large valance ) to complete this designer look.

$ 10.00 additional to base price

Decorative Tape

Wide tape replace the braided cords, increase privacy and light control by covering the routed holes. Cloth tape is attached in the front and the back of the blind. For color options please check under "Colors" tab.

30% additional to base price

Cut Out’s

Cut outs are used when there is an obstruction that will not allow the blind or shade to be lowered properly. Commonly in kitchens & bathrooms where tile has been installed in the inside frame of the window. For special measuring instructions contact customer service.

$ 10.00 per cut additional to base price